I can see the quantitative results of the QuickCheck analysis; however, is there a way to see the results presented visually?
In order to see the results of the QuickCheck analysis visually, the following steps need to be taken.
After the QuickCheck quantitative results have been calculated for a given QuickCheck configuration (template), you will need to switch from the “Patient 3D Dosimetry workspace” to the “2D plan verification workspace”.
Once there, locate and highlight the dataset under Dataset1 that has the QuickCheck icon (either pass or fail) to the left of it. This is the measured data for the QuickCheck 2D comparison, so click and drag it to Dataset2 below.
Also, under Dataset1 is the dataset called, “predicted response”. This is what was used as the reference dataset during the QuickCheck calculation, so let it stay in Dataset1
After both datasets are loaded, data analysis can be performed, via the calculations available in the lower left Results pane of the 2D Workspace. Normally, only the gamma or dose difference results are calculated in the QuickCheck, so these are what would be calculated here. However, it is possible to perform any other type of available analysis here as well, e.g Quotient, DTA, etc.
From here, it is possible to perform and view the QuickCheck analysis results (either dose difference or gamma) on a sectional, segment, beam, or total integral plan basis. To select which way you would like to view the data, just right-click on the measurement data that has the QuickCheck icon next to it under Dataset1, and choose your preferred view.