Question
How does the back panel of the DOSE-X look like and what connections are possible?
Answer
This is also part 16 of the training course about DOSE-X.
Automated summary:
The video provides an overview of the back panel of the DOSE-X device. The video starts with a brief introduction with background music and then proceeds to focus on the back panel of the device.
The speaker explains that there are several possibilities available on the back panel. The left side of the panel contains the power supply and a switch to turn the device on and off. The speaker then goes on to describe that there is an Ethernet cable port available that allows the user to connect to the device remotely. The Ethernet cable is necessary for firmware version 2.0 and later.
The video then explains that there is a red connector available on the back panel that enables the user to add a bias voltage. Finally, the speaker points out that on the right side of the panel, there are connectors available that allow the user to connect a detector. Depending on the version of the device, the user can connect either a TNC or BNC connector.
Towards the end of the video, the speaker briefly mentions that there is information available on the bottom of the panel regarding the device's serial number and other information. The video ends with a thank you message from the speaker.
Overall, the video provides a quick overview of the back panel of the DOSE-X device, highlighting its various features and possibilities available for the user.