Question
When perform FFF profile analysis, I just want to apply the Inflection Points for big field size, not for the smaller fields. How to set up like this?
Answer
Please follow below steps:
In the Use from Fieldsize, input the field size that you want to start applying Inflection Points.
Like Above, when you input 150mm in the box, the Inflection Points method will be applied from field size 150mm to the maximum field.
PS:
The checkbox Inflection Points is not a switch to the Inflection function, it just enables/disabled the display of the Inflection point.
If you enable it, you can see your Inflection Points like below; if you uncheck it, the Inflection Point column is hidden, but it has no influence on the analysis result.