Skip to main content
IBA Dosimetry Service & Support Help Center home page
IBA-Dosimetry.com Support Portal Sign in Submit a request
Deutsch 简体中文
  1. IBA Dosimetry Service & Support
  2. Relative Dosimetry
  3. myQA Accept

myQA Accept

  • How to migrate detectors in "Common-Settings" from Accept 7.X Software to a newer Version?
  • What's new in myQA Accept 9.0 SWP-2022-0006 (9.0.17.0)
  • How to use the 3D dose cube import functionality in myQA Accept 9 and newer versions?
  • How to verify the integrity of the myQA Accept 9.0 upgrade installer with a checksum (SHA)?
  • What's new in myQA Accept 9.0?
  • Differences in the coordinate system in the myQA Accept application vs the coordinate system in an OmniPro Accept 6.X ASCII file.
  • I'm not able to install myQA Cockpit and myQA Accept from the DVD start page, what are the options?
  • What do the terms, Normalized Field, Current Field, and Ratio used in the .opab data used by myQA Accept format mean?
  • How to perform automated CAX measurement queue at a gantry angle other than zero.
  • How to limit the effect of hysteresis in your scanned data?
  • How to set up an IBA Dosimetry water phantom for half profiles measurements (video)?
  • How to upgrade to myQA Accept 2020-002 or 2021-001?
  • How to solve the invalid character error when launching Accept?
  • How to upgrade myQA Accept?
  • What OmniPro Accept Version is the last one to be compatible with the CU500E?
  • What to do if there is a steep drop/ peak in the penumbra and the tail seems to be up-side down/ mirrored at x=0?
  • Coordinates button does not have the green check mark? (Gantry Coordinates are not set)
  • How to set the Inflection Points just for big field sizes in FFF profile analysis?
  • What to do if you see the error "NaN" in the positioning panel in myQA Accept?
  • Why is the Connect button greyed out in myQA Accept?
  • How should I exchange chambers & diodes during scanning?
  • How to extract profiles from a MatriXX/Startrack measurement?
  • My PDD is lower/higher than expected, what can be the possible causes?
  • Scan continues when beam loss, what can be the possible cause?
  • How to create Symmetric Step Points in myQA Accept?
  • How to select scan mode in myQA Accept?
  • What are the steps to convert ionization to dose in case of Electron Dosimetry for myQA Accept?
  • How to convert .rfb file to .asc file in myQA Accept?
  • How to check if EPOM has been applied to measurement or not?
  • How does Effective point of measurement (EPOM) correction work in myQA accept?
  • Next ›
  • Last »
© IBA 2020 | All rights reserved
Contact Imprint Privacy Statement