Radcal Accu-Gold Prodcuts
- Conformance Testing & Certified Calibration Overview
- Radcal AG2, AG3 software exporting to Excel failure
- IBA-Radcal AGT3 No profiles appear.
- How to Change MS 64-bit Office to 32-bit Office for Accu-Gold Excel
- Using Accu-Gold with Apple M1
- Accu-Gold kV Outputs
MagicMaX
- Untitled
- Entrance Dose Measurement with XR Detector of MagicMaX
- How to use the CT chamber (10XF-3CT) for MagicMaX with phantoms?
- Can I measure HVL and Filtration with a MagicMaX CT Ionization chamber (DCT10-MM or 10XF-3CT)?
- Which CT scan mode can be used for the 10XF-3CT ionization chamber?
- Can I use computers with ARM processors with the MagicMaX and the MagicMaX Software?
KermaX-plus
- Which Type of KermaX-plus Chamber has the Built-in Sensor for Temperature and Pressure Correction?
- What cable lengths are available as KermaX-plus connection cables?
- Is a KermaX-plus with a serial interface (e.g. 120-131HS/RS485) compatible with the KermaX-plus SDP display (120-210)?
- How do I set the KermaX-plus IDP interface for the PC?
- Can I use a PoE network switch for the KermaX-plus 120-131 ETH solution as a power supply?
- KermaX-plus Interface - What is the difference between %M and %A commands
DosimaX plus
- Dosimax plus selection menu - Detector damage due to incorrect selection?
- How to turn on/ off the 20 seconds limit of the DosimaX plus?
- The DosimaX plus A (HV) shows increasing values without being irradiated
- Can I connect the DCT10-MM to a DosimaX plus A HV?
- How often do I need to re-calibrate my Dosimax plus?
- How to change the contrast of the Dosimax Plus?
Luminance Meter
- Is a "MTK" inspection according to German §14 MPBetreibV required for LXcan / LXplus?
- LXcan only works if it is connected to the PC/laptop via USB connection cable
- Can I use the LX-LS illuminance sensor with several LXcan?
- Is the LXcan compatible with Windows 10?
- Where can I download Windows drivers for the LXplus luminance meter?
- How to set up the LXcan in combination with LX-LS sensor?
Software
- Is DisplayQ version 1.4.3 compatible with Windows 10 or Windows 11?
- It shows error message while trying to export report from DicomCurve software, what can I do?
- What is the difference between MTF and MTF-f in relation to the IQ Analyzer Software?
- DisplayQ Dicom Curve - Activation error
- Is there a demo license for the IQ Analyzer Primus software?
- The MagicMaX Software is showing "The connected Device is not compatible", although the correct version is installed and the MagicMaX is connected, what can I do?