BluePhantom 2
- How to define a network gateway for the CCU?
- Why is it difficult to compare 2D array measurements with water phantom measurements?
- How do I perform a hard reboot of the CCU?
- Where should I connect the Remote Control/Hand Pendant for the BP2/SmartScan/myQA BluePhantom3?
- What is part of a Preventive Maintenance Inspection (PMI) on a BP2 with CCU?
- The CCU has 3 solid colored lights and the BluePhantom2 system cannot be used
- How to perform the initial zero positioning with the BluePhantom2 / SMARTSCAN Phantom/myQA BluePhantom3?
- Can the BP1 drive control cable be used with the new BP2/ Smartscan?
- Is it possible to use the LINAC's monitor chamber as a reference detector in CCU?
- How to mount and dismount the leveling pins?
- How to clean Water Reservoir?
- How to setup Farmer type chamber in Blue Phantom 2/myQA BluePhantom3 to measure absolute point dose ?
- My Blue Phantom 2 fails to move when requested, What troubleshooting steps can I take?
- An axis is not moving, what can be done for troubleshooting?
- How to set the limits for detector movement?
- How to set the Zero position correctly on the BP2/myQA BluePhantom3 hand control?
- What detector holders are available for BP2/myQA BluePhantom3?
- How to perform Half-Field Profile measurements?
- HV drops or is unstable in myQA Accept, what shall I do?
- How to set TMR measurement in BP2//myQA BluePhantom3 tank?
- My BP2 hand control displays asterisk ( *** ) instead of sensor position, what can I do?
- What to do when CCU cannot connect to XXsetup?
- How do I troubleshoot Noisy Scans?
- How much distilled water do I need to fill the reservoir?
- What type of water should I use for my water reservoir?
- How to reset the fuse on BP2 water reservoir?
- My BP2 water reservoir doesn't work, what shall I do?
- How to update firmware for CCU and hand control?
- Why are my Blue Phantom mechanics oscillating?
- Why is the red error light flashing on my Common Control Unit (CCU)?